BMS Performance S55 Intake – BMW F8X M2/M3/M4

Description

Gain up to 10+whp along with terrific sound

Finally, an affordable intake system worthy of your S55 BMW M2C, M3, and M4! The Burger Motorsports S55 BMW Performance Intake retains everything that’s good about the OEM intake including the cold air ducting and lightweight heat shielding airbox bottom but replaces the top end of the intake with higher flow ducting and quality inverted cone air filters to match.

During our dyno testing the BMS S55 BMW Performance Intake performed the same or better than other S55 intakes tested posting gains of up to 10+ horsepower to the wheels at 25psi+ boost levels. Note the OEM S55 air intake flows very well from the factory so gains are mostly present at higher boost levels and higher RPM where airflow requirements are highest. In addition to freeing up some power turbo spool speed was improved, and there is an incredible sound improvement. You’ll finally be able to hear your turbo spooling!

Our intake temperature testing found no significant difference from the factory intake during both sustained cruise and full-throttle operation.

Installation is easy and fully reversible. Includes BMS proprietary high flow inverted cone filters that can be cleaned every 15-20k miles using an S&B cleaning kit and will last the life of the car.

Our Burger Motorsports inverted cone filters not only outflow your stock paper filter and last the life of your vehicle, they also include a built-in velocity stack. Velocity stacks allow even more air to be smoothly sucked into your intake system and are used in most racing applications.

Features and Benefits

• Adds up to 10+ Horsepower
• Dramatic sound improvement
• Super fast install and removal
• Improves throttle response
• Retains OEM airbox base as a heat shield
• Retains OEM cold air ducting
• Now available with red or blue filters
• Looks great under the hood
• Cleanable and reusable filters

Kit Includes

• (2) BMS 3″ aluminum intake tubes
• (2) Renewable BMS inverted cone performance filters
• (1) 3″ coupler
• (2) 3″ clamps
• (4) M4x0.7x14mm MAF screws

Fitment

• BMW M2: 2018-2022 S55 BMW F87 M2 Competition (S55 engine only)
• BMW M3: 2015-2020 S55 BMW F80 M3
• BMW M4: 2015-2020 S55 BMW F82 F83 M4, M4 GTS, M4 CS